\relax 
\citation{brite1,brite2}
\@writefile{toc}{\contentsline {chapter}{\numberline {Chapter{} 7}{Experiments}}{36}}
\newlabel{experiments}{{7}{36}}
\@writefile{toc}{\addvspace {10pt}}
\@writefile{toc}{\contentsline {section}{\numberline {I}Experimental Setup}{36}}
\@writefile{toc}{\contentsline {subsection}{\numberline {\it  A.}BRITE}{36}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.1}{\ignorespaces The distribution of all the nodes in a plane}}{37}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{locationsFigure}{{7.1}{37}}
\@writefile{toc}{\contentsline {subsection}{\numberline {\it  B.}The Trace}{37}}
\citation{zipflike}
\@writefile{toc}{\contentsline {subsection}{\numberline {\it  C.}Zipf-like Behavior of Requests}{38}}
\@writefile{lot}{\contentsline {table}{\numberline {7.1}{\ignorespaces Comparison of performance and load for plain and spatial Chord}}{39}}
\@writefile{lot}{\addvspace {10pt}}
\newlabel{initial}{{7.1}{39}}
\@writefile{toc}{\contentsline {section}{\numberline {II}Results}{39}}
\@writefile{lot}{\contentsline {table}{\numberline {7.2}{\ignorespaces Comparison of performance, load and replication overhead for the different cases}}{40}}
\@writefile{lot}{\addvspace {10pt}}
\newlabel{Comparison}{{7.2}{40}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.2}{\ignorespaces Comparison of the distance traveled per request, across the 3 systems}}{40}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{comparedist}{{7.2}{40}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.3}{\ignorespaces Comparison of the hops taken per request, across the 3 systems}}{41}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{comparehops}{{7.3}{41}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.4}{\ignorespaces Load in the system for plain Chord}}{42}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{onlyplain}{{7.4}{42}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.5}{\ignorespaces Load in the system for Chord with 2 rings, single replica}}{43}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{onereplica}{{7.5}{43}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.6}{\ignorespaces Load in the system for Chord with 2 rings, multiple replicas, maximum 15 replicas per document, maximum 20 new replicas created on a node each time replication protocol is run}}{44}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{multreplicas3}{{7.6}{44}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.7}{\ignorespaces The performance of the system deteriorates as document count is increased, if replication period is kept the same}}{45}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{perplot}{{7.7}{45}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.8}{\ignorespaces The number of replicas created settles down when the system reaches a {\it  steady state} - 1000 documents, 2 rings, multiple replicas}}{46}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{countreplicas}{{7.8}{46}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.9}{\ignorespaces The number of replicas created stays high throughout the simulation - 10000 documents, 2 rings, multiple replicas}}{47}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{countreplicas2}{{7.9}{47}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.10}{\ignorespaces Histogram for the load on each node, for the system with only the plain ring}}{48}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{plainhist}{{7.10}{48}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.11}{\ignorespaces Histogram for the load on each node, for the system with 2 rings and one replica per document}}{48}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{2ringsonereplicahist}{{7.11}{48}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.12}{\ignorespaces Histogram for the load on each node, for the system with 2 rings and multiple replicas per document}}{49}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{2ringsmultreplicashist2}{{7.12}{49}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.13}{\ignorespaces Comparison of the performance of the system with two rings for different values of maximum number of replicas per document and number of replicas that can be created at a node at one time}}{49}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{threedPerf}{{7.13}{49}}
\@writefile{lof}{\contentsline {figure}{\numberline {7.14}{\ignorespaces Comparison of the load in the system with two rings for different values of maximum number of replicas per document and number of replicas that can be created at a node at one time}}{50}}
\@writefile{lof}{\addvspace {10pt}}
\newlabel{threedLoad}{{7.14}{50}}
\@setckpt{experiments}{
\setcounter{page}{51}
\setcounter{equation}{0}
\setcounter{enumi}{5}
\setcounter{enumii}{2}
\setcounter{enumiii}{0}
\setcounter{enumiv}{0}
\setcounter{footnote}{0}
\setcounter{mpfootnote}{0}
\setcounter{part}{0}
\setcounter{chapter}{7}
\setcounter{section}{2}
\setcounter{subsection}{0}
\setcounter{subsubsection}{0}
\setcounter{paragraph}{0}
\setcounter{subparagraph}{0}
\setcounter{figure}{14}
\setcounter{table}{2}
\setcounter{corollary}{0}
\setcounter{lemma}{0}
\setcounter{theorem}{0}
\setcounter{claim}{0}
\setcounter{proposition}{0}
\setcounter{parentequation}{0}
\setcounter{subfigure}{0}
\setcounter{lofdepth}{1}
\setcounter{subtable}{0}
\setcounter{lotdepth}{1}
\setcounter{r@tfl@t}{0}
\setcounter{plate}{0}
\setcounter{fchapter}{0}
}